Rockwell Automation 6189V-xxxx Non-display Industrial Computers User Manual - Manual (Page 100)

100 Rockwell Automation Publication 6177R-UM002D-EN-P - October 2014
Appendix B Accessories Installation
Install an Add-in Card The motherboard of the 750R and 1450R computers has four PCI slots that
support installation of half-length PCI add-in cards.
• One PCI slot
• Three PCI-express (PCIe) slots
Besides these four PCI slots, the 1450R computer has a slot expansion board that
provides another three PCI slots.
Follow these steps to install an add-in card.
1. Follow the steps for Pre-configuration on page 36 .
2. Remove the cover as detailed in Remove the Cover on page 38 .
3. Remove the chassis cross member or I/O card retention bracket as detailed
in Install I/O Card Retention Bracket on page 98 .
4. Locate an empty PCI slot.
ATTENTION: Add-in cards are sensitive to ESD; handle with care.
• Hold cards only by the edges.
• Do not touch the card connectors, components, or circuits.
• After you remove an add-in card, place it on a flat, static-free surface, with the
component side up.
• Do not slide the card over any surface.
IMPORTANT Use an antistatic wriststrap that is connected to the work surface, and properly
grounded tools and equipment.
PCI expansion board slots of
the 1450R computer.
Motherboard PCI expansion slots
for 750R and 1450R computers.