Rockwell Automation 6189V-xxxx Non-display Industrial Computers User Manual User Manual
Page 60
60
Rockwell Automation Publication 6177R-UM002D-EN-P - October 2014
Chapter 5
UEFI Set-up Utility
SATA Configuration (for computers with Windows 8.1, 7, or XP operating systems)
Parameter
(1)
(1) See
for an explanation of common buttons near the bottom of screen.
Description
SATA Mode
Select an operation mode for the onboard SATA controller.
Options: Disabled, IDE Mode, AHCI Mode (default), or RAID Mode
(2)
(2) Applies only to computers that ship with Windows Server operating systems. For computers that ship with two HDDs but no
operating system, the HDDs are in AHCI mode instead of RAID and each drive acts independently.
SATA Port (0, 1, 2, 4)
Indicates the SATA HDD connected to the SATA connector.
Hot Plug
Enables or disables hot plug support for the SATA port.
Options: Enabled (default) or Disabled
IMPORTANT: Make sure all writes to HDD are complete before your remove the
HDD from the system to avoid risk of data corruption.
External SATA Port
Enables or disables eSATA port.
Options: Enabled (default) or Disabled