Rockwell Automation 6189V-xxxx Non-display Industrial Computers User Manual - Manual (Page 37)

Rockwell Automation Publication 6177R-UM002D-EN-P - October 2014 37
Component Replacement Chapter 4
Post-configuration Follow these steps after you install or you remove a hardware component.
1. Verify that all components are installed according to instructions.
2. Make sure that no tools or loose parts are left inside the computer.
3. Reinstall any expansion boards, peripherals, chassis cross members, and
system cables that were previously removed.
4. Reinstall the cover according to the instructions on page 39 .
5. Reconnect all external cables and power to the computer.
6. Press the power switch to start the computer.
Required Tools The following tools are required for component replacement:
• #2 cross-head screwdriver
• Antistatic wriststrap
• Side cutters (to cut cable ties, if necessary)