Rockwell Automation 6189V-xxxx Non-display Industrial Computers User Manual - Manual (Page 22)

22 Rockwell Automation Publication 6177R-UM002D-EN-P - October 2014
Chapter 2 Installation
Mounting Clearance
Requirements When selecting an installation site for the computers, allow a minimum of
76 mm (3 in.) clearance at the front and rear of the computer for adequate
ventilation and cable connections.
Mounting Hardware The table lists the hardware that is required for each type of installation.
IMPORTANT Computers generate heat. Therefore, do not operate the computer in an
enclosure with the minimum clearances unless adequate ventilation or other
methods are used to lower the temperature within the enclosure.
Allow enough clearance to install or remove peripheral components, such as
storage drives.
Description Cat. No. Application
Supplied
with
computer?
Applies to Cat. No.
Mounting
brackets (2) N/A Machine or wall Yes 750R 6177R-MMPXP
6177R-MMPW7
6177R-MMPNO
6177R-MMSS8
6177R-MMS12
6177R-MMAW7
6177R-MMAW8
6177R-MMSNO
Rack handles (2) N/A Rack Yes 1450R 6177R-RMPXP
6177R-RMPW7
6177R-RMPNO
6177R-RMRNO
6177R-RMSS8
6177R-RMS12
6177R-RMAW7
6177R-RMAW8
6177R-RMSNO
Rack slides (2) 6189V-RACKSLIDES Rack No