Rockwell Automation 6189V-xxxx Non-display Industrial Computers User Manual - Manual (Page 79)

Rockwell Automation Publication 6177R-UM002D-EN-P - October 2014 79
UEFI Set-up Utility Chapter 5
AMI Restore
Perform the following steps to restore your computer from a system image backup.
1. Click the AMI Rescue menu to access the AMI Restore screen.
2. Click AMI Restore.
3. Select the appropriate volume from the list.
‘Recovery’ is the volume name where the default backup of factory images
is stored.
4. Click Next.
IMPORTANT When you restore from a back-up image, all data on the target drive is
replaced. Verify that all data is backed up before you proceed with the
following steps.
IMPORTANT Computers with the Windows Embedded 8.1 Industry Pro operating
system do not contain a factory image backup in the Recovery partition.
IMPORTANT Any USB mass storage drive or eSATA hard disk drive must be formatted
as FAT32, have a drive label other than ‘Recovery,’ and be non-blank.