Rockwell Automation 1440-VLF02-01RA XM-121 Absolute Shaft Module - Manual (Page 50)

Publication GMSI10-UM014D-EN-P - May 2010
42 Installing the Absolute Shaft Module
Figure 2.25 Reset Switch
The switch can be used to reset all latched relays in the module. This includes
the relays in the Expansion Relay Module when it is attached to the XM-121
module.
Installing the XM-121
Absolute Shaft Firmware Before you can use the XM-121 Absolute Shaft module, you must install the
Absolute Shaft firmware onto the XM-121 Low Frequency Dynamic
Measurement module. The Absolute Shaft firmware is provided on the XM
Documentation and Configuration Utility CD (version 5.0 or later) that is
packaged with the XM modules.
Complete the following steps to install the XM-121 Absolute Shaft firmware.
1. Make certain you have installed the XM Serial Configuration Utility onto
the computer that will be connected directly to the XM-121 module.
Refer to the XM-12X Dynamic Measurement Modules Installation
Instructions for assistance.
2. Insert the XM Documentation and Configuration Utility CD into the
CD-ROM drive of the computer.
IMPORTANT
The Reset switch resets the relays only if the input is no
longer in alarm or the condition that caused the alarm is no
longer present.
Press the Reset
Switch to reset the
relays
TIP
XM firmware update files are available for download from
the XM Firmware Update page at
http://support.rockwellautomation.com