Rockwell Automation 1440-VLF02-01RA XM-121 Absolute Shaft Module - Manual (Page 53)

45 Publication GMSI10-UM014D-EN-P - May 2010
Chapter
3
Configuration Parameters
This chapter provides a complete listing and description of the Absolute Shaft
parameters. The parameters can be viewed and edited using the XM Serial
Configuration Utility software and a personal computer. If the module is
installed on a DeviceNet network, configuring can also be performed using a
network configuration tool such as RSNetWorx (Version 3.0 or later). Refer to
your configuration tool documentation for instructions on configuring a
device.
For information about See page
Channel Parameters 46
Signal Processing Parameters 48
Measurement Parameters 48
Tachometer Parameters 52
Alarm Parameters 55
Relay Parameters 59
4-20 mA Output Parameters 63
Triggered Trend Parameters 64
SU/CD Trend Parameters 66
I/O Data Parameters 68
Data Parameters 69
Device Mode Parameters 72
IMPORTANT
The
The appearance and procedure to configure the parameters
may differ in different software.