Rockwell Automation 1440-VLF02-01RA XM-121 Absolute Shaft Module - Manual (Page 51)

Publication GMSI10-UM014D-EN-P - May 2010
Installing the Absolute Shaft Module 43
3. Connect the computer to the XM-121 module using the special serial
cable. Refer to Serial Port Connection on page 34.
4. Power up the XM-121 module if you haven’t already done so, and start
the XM Serial Configuration Utility program. Click the Start program,
and then select Programs > Entek > XM > Serial Config Utility.
5. Click the Configure button on the XM Serial Configuration Utility
screen. The XM-121 LF Dynamic Measurement Module Configuration
Tool screen appears.
TIP
The Serial Configuration Utility defaults to the COM
1 serial port. If you are not using COM 1, select the
correct COM port on the XM Serial Configuration
Utility screen.
When you are connected to an XM-121 module, the
XM-121 module type appears on the XM icon, and
the connection icon changes to show the
connection.