Metrohm 877 Titrino plus - Manual (Page 102)

7.2 Endpoint titrations (SET)
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
92 ￭￭￭￭￭￭￭￭
877 Titrino plus
Selection on | off
Default value off
7.2.8 Statistics
Menu ▶ Parameters ▶ Statistics
The statistics calculation of a multiple determination is switched on under
Statistics and it is defined how many determinations the series contains.
Statistics
If this funtion is switched on, then statistics calculations will be carried out
for all of the defined results.
Selection on | off
Default value off
Number of samples
The number of determinations that are carried out for the statistics calcu-
lations.
If an additional determination must be added to the determination series,
because one determination was incorrect, for example, then this can be
accomplished in the statistical overview (see Chapter 5.11, page 40).
Input range 2 - 20
Default value 3
7.2.9 Reports
Menu ▶ Parameters ▶ Reports
The reports that will be printed out automatically in connection with a
determination are defined under Reports.
Results
The result report contains the calculated results, equivalence points and
endpoints, sample data, etc.
Selection on | off
Default value off
Curve
Curve report. The width of the curve is defined in the system settings (see
"Graphics width", page 63).
Selection on | off
Default value off