Thermcraft XST-3-0-36-3V - Manual (Page 112)

Configuration Installation and Operation Handbook
6-14 2408 and 2404 Controller
Name Description Values Meaning
AA Alarm relay configuration
id Identity rELy Relay output
Func Function nonE No function
dIG Digital output
SEnS Digital output sense nor Normal (output energises when
TRUE, e.g. program events)
inv Inverted (output de-energises when
TRUE, e.g. alarms)
The following digital events appear after ‘ SEnS’. Any one, or more, of the events can be
combined on to the output (see Fig. 6-2) by selecting ‘ YES’ in the lower readout.
1 - - - Alarm 1 active YES / no (- - -) = alarm type (e.g. FSL).
2 - - - Alarm 2 active YES / no If an alarm has not been configured
3 - - - Alarm 3 active YES / no in ‘AL ConF’ list, then display will
4 - - - Alarm 4 active YES / no differ:- e.g. Alarm 1 = ‘AL 1’.
mAn Controller in manual mode YES / no
Sbr Sensor break YES / no
SPAn PV out of range YES / no
Lbr Loop break YES / no
Ld.F Load failure alarm YES / no
tunE Tuning in progress YES / no
dc.F Voltage output open circuit, or mA
output open circuit YES / no
rmt.F PDS module measurement
connection or remote input open
circuit YES / no
iP1.F Input 1 failure YES / no
nw.AL New Alarm has occurred YES / no
End End of setpoint rate limit, or end
of program YES / no
SYnc Program Synchronisation active YES / no
PrG.n Programmer event output active,
where ‘n’ = event number from 1
to 8. (Not available with
8-segment programmer.) YES / no
Figure 6-2 Combining several digital events on to one output
dIG
SEnS
nor
inv Output
Module
Digital Events
OR