Thermcraft XST-3-0-36-3V - Manual (Page 87)

Installation and Operation Handbook Programmer Operation
2408 and 2404 Controller 5-5
RUNNING A PROGRAM FROM THE RUN LIST
The Run List
From the Home display, press
until you reach the ‘ run’ list
header.
Press
Program number
This display only appears on programmers that can store more
than one program. Use
or to select the required program
number, from 1 to 4, or 1 to 20, depending on the particular
controller.
Alternatively, the program number can be selected remotely, using
digital inputs on the rear terminals. See the section on
Configuring Digital Inputs to Select a Program Number for
information on how this is done.
Press
Status selection
Use
or to select:
• run: Run program.
• hoLd: Hold program.
• OFF: Program reset.
After two seconds, the lower readout blinks and the chosen state is
now active.
To return to the Home display press
and together.
Other parameters
To access the other parameters in the ‘
run’ list, continue to press
. These parameters are shown in the ‘Program run list’ in
Chapter 2, Parameter Tables. They show the current status of the
active program.
Temporary changes
Temporary changes can be made to the parameters in this ‘
run’ list, (for example a setpoint,
ramp rate, or an unelapsed time), by first placing the programmer into ‘ hoLd’. Such changes
remain active only for the duration of the segment; the segment parameters will revert to their
original (stored) values whenever the segment is re-executed.