Thermcraft XST-3-0-36-3V - Manual (Page 224)

Programmer Operation Installation and Operation Handbook
5-8 2416 Controller
CONFIGURING THE PROGRAMMER
Configuration defines:
• the number of stored programs
(Multi programmer only)
• the holdback strategy
• the power fail strategy
• the servo type
• if event outputs are available.
(Multi programmer only)
When first installing a programmer, you should check that the configuration conforms to your
requirement.
To check or change the configuration, select Configuration level. See Chapter 6.
Programmer list header
After selecting Configuration mode, press until the
PROG
ConF header is displayed.
Press
Number of programs
Use or to select:
• nonE : Disable built-in 8-segment programmer
• 1 : Enable built-in 8-segment programmer
For 16-segment programmers:
• nonE : no programs
• 1 : One stored program
• 4 : Four stored programs
Press
Holdback Strategy
Use or to select:
• SEG : Holdback type to be set in each segment
• ProG : Holdback type to be set for the whole
program
Press Continued on the next page.
HbAc
SEG
Ptyp
4
prog
Conf