Thermcraft XST-3-0-36-3V - Manual (Page 229)

Installation and Operation Handbook Programmer Operation
2416 Controller 5-13
Ramp rate
Ramp rate for ‘
rAtE’ segments.
Using or , set a value for the ramp rate, ranging from 0.00
to 999.9 (the units will be the ramp units (‘
rmP.U’) set earlier in
this sequence).
Press
Duration time
Time for a ‘
dwEl’ segment, or time to target for a ‘rmP.t’
segment.
Set the time using
or . You have set the units earlier in this
sequence.
Press
Called program number
Only appears for ‘
cALL’ segments.
(4-program controllers only)
Set a called program number from 1 to 4, using or .
Press
Number of cycles of the called program
Only appears for ‘
cALL’ segments.
(4-program controllers only)
Set the number of cycles of the cALLed program from 1 to 999,
using
or .
Press
Continued on the next page.
rate
1.0
dur
1.0
Prg.n
4
cyc.n
1