Sony DCR-TRV10 - Manual (Page 110)

Troubleshooting
If \ ou run into an\' prohletn using wKir camcorder, use tlio tollrnr ing table to
troubleshoot the problem. If the problem persists, disconnect the power source and
contact your Sony dealer or kKal authorized Sony seryice facility. If ''C:nn:nCl"
appears on the LCD screen or in the x'iewfinder, the self-diagnosis display function has
worked. See page 116.
in the recording mode
Symptom Cause and/or Corrective Actions
START/STOP does not ijperate. • The POWER switch’ls set to VTR.
■> Set it to CAMERA, (p. 15)
• The POWER switch is set to OFF.
Set the POWER switch to CAMERA, (p. 15)
• The tape has run out.
-> Rewind the tape or insert a new one. (p. 14, 25)
• The write-protect tab is set to expose the red mark.
Use a new tape or slide the tab. (p. 14)
• The tape is stuck to the drum (moisture condensation).
Remove the cassette and leave your camcorder for at
least 1 hour to acclimatize, (p. 120)
Recording stops in a few seconds. • START/STOP MODE is set to 5SEC or
Set it to A (P-20)
The power goes off. • While being operated in the CAMERA mode, your
camcorder has been in the standby mode for more than 5
minutes.
■> Set the POWER switch to OFF and then to CAMERA
again, (p. 15)
The image on the viewfinder screen
is not clear.
• The viewfinder lens is not adjusted.
■* Adjust the viewfinder lens. (p. 18)
The SteadyShot function does not
work. • STEADYSHOT is set to OFF in the MENU settings.
-» Set it to ON. (p, 72)
The autofocusing function does not
work. • FOCUS is set to MANUAL.
Set it to AUTO. (p. 45)
• Shooting conditions are not suitable for autofocus.
Set FOCUS to MANUAL to focus manually, (p. 45)
The fader function does not work. • START/STOP MODE is set to 5SEC or 1.
Set it to A. (p. 20)
•.The digital effect function is working.
•¥ Cancel it. (p. 39)
The 0 indicator flashes in the
viewfinder or on the LCD screen.
• The video heads may be dirty.
Clean the heads using the Sony DVM12CL cleaning
cassette (not supplied), (p. 121)
The picture does not appear in the
viewfinder. • The LCD panel is open.
Close the LCD panel, (p. 17)
(continued on the following page)