Step 1 preparing the power supply, Connect the power cord to the, Power adaptor. s – Sony DCR-TRV10 User Manual
Page 13
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
step 1 Preparing the power supply
When you use your camcorder for a long time, we recommend that you power it from a
wall outlet usii^ the AC power adaptor.
■
(1) Open the DC IN jack cover, pulling the cover out a little and rotating it,
gi
Connect
the
AC
power
adaptor
to
the
DC
IN
jack
on
your
camcorder
with
the
3.
plug's A mark facing up.
«>
(2)
Connect the power cord to the
AC
power adaptor.
S
(3)
Connect the power cord to a wall outlet.
* •
WARNING
The power cord must only be changed at a qualified service shop.
PRECAUTION
The set is not disconnected from the AC power source (house current) as long as it is
"connected to the wall outlet, even if the set itself has been turned off.
Notes
• The AC power adaptor can supply power even if the battery pack is attached to your
camcorder.
• The DC IN jack has "source priority". This means that the battery pack cannot supply
any power if the power cord is connected to the DC IN jack, even when the power
cord is not plugged into a wall outlet.
• Keep the AC power adaptor away from your camcorder if the picture is disturbed.
Using a car battery
Use Sony DC Adaptor/Charger (not supplied).
13