Adding an audio sound on a recorded tape – Sony DCR-TRV10 User Manual
Page 64
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Audio dubbing
Adding an audio sound on a recorded tape
(
1
)
Insert vour recorded tape into vour camcorder.
(
2
)
Set the POWER switch of your camcorder to VTR.
(3)
LtKate the recording start point by pressing ►. Then press
II
at the point
where you want to start recording to set your camcorder to playback pause
mode.
(4)
Press AUDIO DUB on the Remote Commander .
(5)
Press II on the Remote Commander and at the same time start playing back
the audio you want to record.
The new sound is recorded in stereo 2 (ST2) during playback.
(6)
Press ■ on the Remote Commander at the point where you want to stop
recording.
Monitoring the new recorded sound
To play back the sound
Adjust the balance between the original sound (STl) and the new sound (ST2) by
selecting AUDIO MIX in the MENU settings (p. 72).
V7FI SET
Cr H i F i SOUND
ICTIAUDIO MIX 1 C3C
13 PRETURN STl
a
k
ST2
E
&
rrc
P
(MENU) : END
Five minutes after when you disconnect the power source or remove the battery pack,
the setting of AUDIO MIX returns to the original sound (STl) only. The factory setting
is original sound only.