Sony DCR-TRV10 User Manual
Page 65
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Audio dubbing
Notes
)
• Now sound cannot bo recordod on a tape already recorded in the 16-bit mode (32 kl i
44.1 kHz or 48 kHz) (p. 76).
• When an external microphone is not connected, the recording will be made through
the built-in microphone of your camcorder.
• New sound cannot be recorded on a tape already recorded in the LP mode.
• You cannot add audio w'ith the DV IN/OUT jack.
If you make all the connections
The audio input to be recorded will take precedence o\'er others in the following ordei
• MIC (PLUG IN POWER) jack
• Intelligent accessory shoe
• AUDIO/VIDEO jack
• Built-in microphone
If an i.LINK cable (DV Connecting cable) is connected to your camcorder
You cannot add a sound to a recorded tape.
To add new sound more precisely
Press ZERO SET MEMORY at the point where you want to stop recording later in the
playback mode.
Carry out steps 3 to 5. Recording automatically stops at the point where ZERO SET
MEMORY was pressed.
We recommend you to add new sound on a tape recorded with your camcorder
If you add new sound on a tape recorded with another camcorder (including
DCR-TRV8/TRV10), the sound quality may become worse.
If you disconnect or connect the i.LINK cable (DV connecting cable) to your
camcorder during recording
The recording may stop.