Dynojet 250ix: Pit Installation Guide - Manual (Page 101)

A C C E S S O R I E S
Wheel Clamp
Version 3 In Ground Model 200iPX/250iPX Motorcycle Dynamometer Installation Guide
3-19
8 Place the wheel clamp cover on the wheel clamp.
9 Secure the cable track to the wheel clamp as shown in Figure 3-22 using one
1/4-20 x 1-inch screw removed earlier.
10 Secure the wheel clamp cover using the remaining five 1/4-20 x 1-inch screws
removed earlier.
Figure 3-22: Secure the Cable Track and Wheel Clamp Cover
W HEEL C LAMP F INAL A DJUSTMENTS AND T ESTS
1 Place a stack of catalogs into the wheel clamp.
2 Using the Control Panel, press the close button and observe that the wheel clamp
does close. Hold the button until the motor turns off and the status light is on
steady.
3 Press and hold the right hand wheel clamp button then press the left hand button
to open the clamp.
Refer to “Using the Wheel Clamp” on page 4-6 for more information on using the
Control Panel.
PD133
screw
cable track
wheel clamp cover