Dynojet 250ix: Pit Installation Guide - Manual (Page 155)

D Y N O P R E P A R A T I O N F O R U P G R A D E I N S T A L L A T I O N
Dyno Preparation
Version 3 In Ground Model 200iPX/250iPX Motorcycle Dynamometer Installation Guide
E-5
D ISCONNECTING THE C ABLE T RACK AND M OVING THE C ABLES
1 Remove the 1/4-20 screw securing the cable track bracket to the wheel clamp and
move the cable track aside. Replace this screw in the wheel clamp.
2 Remove the two 4-40 screws securing the wheel clamp cable track bracket to the
cable track.
3 Flip the wheel clamp cable track bracket over and secure to the cable track using
the two 4-40 screws removed earlier.
4 Remove the two 8-32 screws securing the cable track bracket to the junction box
and set aside.
5 Lift the cable track and the two cables and place on the left side of the tire
carriage.
6 Remove the two screws securing each blower connector to the junction box and
set aside.
7 Pick up the blower connectors and cables and move to the left side of the
carriage.
Note: Be sure to make note which is the left blower connector and which is the
right blower connector.
Figure E-4: Remove the Cable Track and Blower Connectors
junction box
cable track bracket
wheel clamp
wheel clamp cable
track bracket
blower connectors