Pit covers installation – Dynojet 250ix: Pit Installation Guide User Manual
Page 72
In Ground Model 200iPX/250iPX Motorcycle Dynamometer Installation Guide
C H A P T E R 2
Pit Covers Installation
2-50
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
PIT COVERS INSTALLATION
Use the following instructions to install the pit covers.
You will need the following parts:
• 21200025
Drum Guard Mounting Bracket, iPX module
• 21200038
Drum Safety Cover
• 21226105
Left Pit Cover
• 21226106
Eddy Current Brake Pit Cover
• 21229106
Drum Guard, iPX module (2)
• 21229111
Drum Guard, Dyno Module (2)
• 21624103
Drum Guard Mounting Bracket, Dyno Module
• 36561045
Screw, 1/4-20 x 5/8", Pan-Head, Torx (24)
• 36580434
Bolt, 3/8-16 x 1/2", Button-Head, Flange, Allen (18)
• 61100005
Middle Pit Cover
• 61100006
Right Pit Cover
• DM150-020-005
Nut, crush, 1/4-20 (8)
1
Place the eddy current brake cover over the brake module.
2
Loosely secure the eddy current brake cover using four 3/8-16 x 1/2-inch
button-head flange screws. Do not tighten.
Figure 2-40: Install the Eddy Current Brake Pit Cover
PD211