Installing the left blower assembly – Dynojet 250ix: Pit Installation Guide User Manual
Page 44
In Ground Model 200iPX/250iPX Motorcycle Dynamometer Installation Guide
C H A P T E R 2
Left Side Blower and Monitor Arm Installation
2-22
I
NSTALLING
THE
L
EFT
B
LOWER
A
SSEMBLY
1
Insert a plastic cap in both ends of each arm.
2
Place one 1/4-inch thick poly washer around the pin on the blower mount.
3
Place the lower blower arm over the blower mount pin.
4
Place a 3/8-inch thick metal washer on top of the lower blower arm.
5
Secure the lower blower arm using the clamp lever.
6
Place a 1/8-inch thick poly washer around the pin on the upper blower arm.
7
Insert the pin on the upper arm into the lower arm.
8
Place a 1/8-inch thick poly washer around the pin on the blower assembly.
9
Insert the pin on the blower assembly into the upper arm.
Note: The right blower assembly will be installed later.
Figure 2-14: Install the Left Blower Assembly
PD114
poly washer
clamp lever
(not visible)
blower
assembly
metal washer
(not visible)
poly washer
upper blower arm
lower blower arm
poly washer