Dynojet 250ix: Pit Installation Guide - Manual (Page 157)

D Y N O P R E P A R A T I O N F O R U P G R A D E I N S T A L L A T I O N
Dyno Preparation
Version 3 In Ground Model 200iPX/250iPX Motorcycle Dynamometer Installation Guide
E-7
R EMOVING THE C ARRIAGE AND C ARRIAGE P LATE
1 Remove the four 1/4-20 x 1/2-inch button-head flange bolts securing the bearing
bracket and set aside.
2 Using the control panel to run the power carriage, run the carriage screw out of
the carriage assembly and set aside.
3 Slide the carriage assembly towards the rear of the dyno. Remove the carriage
assembly and set aside.
Figure E-6: Remove the Carriage
TC053
bearing bracket
carriage