Dynojet 250ix: Pit Installation Guide - Manual (Page 47)

I N S T A L L A T I O N
Trike Carriage Adapter Installation
Version 3 In Ground Model 200iPX/250iPX Motorcycle Dynamometer Installation Guide
2-25
I NSTALLING THE R IGHT B LOWER M OUNT AND B LOWER A SSEMBLY
You will need the following parts:
• 21600015 Lower Blower Arm
• 26215220 Washer, 3/8", Metal
• 26215520 Washer, 1/8", Poly (2)
• 26215521 Washer, 1/4", Poly (2)
• 35521420 Cap Plug (4)
• 35712991 Clamp Lever
• 37513200 Anchor, Redhead, 3/8" (4)
• 61328101 Blower Assembly
• 61329601 Blower Mount
• 63413001 Upper Blower Arm
• DM150-002-007 Washer, 5/16", Flat (4)
• DM150-019-012 Bolt, 3/8-16 x 1", Hex (4)
1 Using Figure 2-17 as a guide, place the blower mount in a location that works best
for your dyno application.
2 Using the blower mount as a template, mark and drill the four holes needed to
secure the blower mount to the floor.
3 Install the Red Head anchors. Refer to Appendix A for installation instructions.
4 Secure the blower mount to the floor using four 3/8-16 x 1-inch hex bolts and
four 5/16-inch flat washers.
Figure 2-17: Install the Right Blower Mount
111.76 cm
(44.00 in.)
76.20 cm
(30.00 in.)
PD199