Dynojet 250ix: Pit Installation Guide - Manual (Page 143)

E E C F I N G E R G U A R D A N D D O O R S A F E T Y S W I T C H I N S T A L L A T I O N
EEC Finger Guards
Version 3 In Ground Model 200iPX/250iPX Motorcycle Dynamometer Installation Guide
C-3
A DJUSTING THE EEC F INGER G UARDS
Once the pit cover plates are installed and adjusted, the EEC finger guards will need
to be adjusted.
1
Loosen the 1/4-20 x 5/8-inch pan head screws and adjust the EEC finger guards so
they are 0.16 cm to 0.64 cm (.0625 in. to .25 in.) from the drum. Tighten the
screws.
2 Check the EEC finger guards regularly to verify the clearance has not changed.
Do not operate the dynamometer without the EEC finger guards properly
installed. The gap between the finger guards and the drum must be less than
0.64 centimeters (0.25 inches).
Figure C-2: Adjust the EEC Finger Guard Clearance
adjust screw
adjust clearance