Dynojet 250ix: Pit Installation Guide - Manual (Page 46)

In Ground Model 200iPX/250iPX Motorcycle Dynamometer Installation Guide
C H A P T E R 2
Trike Carriage Adapter Installation
2-24
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
TRIKE CARRIAGE ADAPTER INSTALLATION
Use the following instructions to install the trike carriage adapter plate, right blower
assembly, and the cable track.
The installation instructions are the same for both the standard and the extended
carriage; verify you use the correct dimensions for the type of carriage you are
installing.
I NSTALLING THE T RIKE C ARRIAGE A DAPTER P LATE
You will need the following parts:
• 15331100 Chain Lube
• 36500009 Screw, 3/8-16 x 1", Button-Head (8)
• 37513200 Anchor, Redhead, 3/8" (8)
• 71300002 Trike Carriage Adapter Assembly
1 Mark the trike carriage adapter plate placement as shown in Figure 2-16.
2 Using the trike carriage adapter plate as a template, mark and drill eight 1/2-inch
holes needed to secure the adapter plate to the floor.
3 Install the Red Head anchors. Refer to Appendix A for installation instructions.
4 Secure the adapter plate to the floor using eight 3/8-16 x 1-inch screws.
5 Lube the tracks with the included lube or use grease.
Figure 2-16: Install the Trike Carriage Adapter Plate
standard carriage
72.39 cm (28.50 in.)
extended carriage
97.79 cm (38.50 in.)
0.635 cm
(0.25 in.)
PD198
mark and drill for
redhead anchors