Dynojet 250ix: Pit Installation Guide - Manual (Page 34)

In Ground Model 200iPX/250iPX Motorcycle Dynamometer Installation Guide
C H A P T E R 2
iPX Drum Module Installation
2-12
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
IPX DRUM MODULE INSTALLATION
When you receive your iPX upgrade kit, examine the exterior of the shipping
container for any visible damage. If damage is detected at this stage, contact the
shipper or Dynojet before proceeding with unpacking.
Use the following steps to unload the iPX drum module and related items. You will
need to provide equipment capable of lifting a minimum of 363 kg. (800 lb.) to move
the crated drum into position in your dyno room.
R EMOVING THE I TEMS FROM C RATE
1 Move the crate to a clear area near your dyno room.
2 Using a pry bar, or a large flat screwdriver, and a hammer, carefully remove the
top and sides of the crate.
3 Remove the following parts from the crate and set aside.
part description part description
drum guard mounting
bracket
P/N 21200025
pit cover, middle
P/N 61100005
drum safety cover
P/N 21200038
pit cover, right
P/N 61100006
cable track mounting
bracket (to trike carriage
adapter)
P/N 21200069
driveline assembly
P/N 62200004
drum guard (2)
P/N 21229106
drum module, pit
P/N 63200002
screw, 1/4-20 x 5/8",
pan-head, torx (12)
P/N 36561045
trike carriage adapter
assembly
P/N 71300002