Dynojet 250ix: Pit Installation Guide - Manual (Page 42)

In Ground Model 200iPX/250iPX Motorcycle Dynamometer Installation Guide
C H A P T E R 2
Left Side Blower and Monitor Arm Installation
2-20
I NSTALLING THE L EFT B LOWER M OUNT
If this is an iX upgrade to an existing 200iP/250iP dyno, skip these instructions and
refer to Appendix E for upgrade instructions.
1
Mark the left blower mount placement as shown in Figure 2-12.
2 Using the blower mount as a template, mark and drill the four holes needed to
secure the blower mount to the floor.
3 Install the Red Head anchors. Refer to Appendix A for installation instructions.
Figure 2-12: Install the Left Blower Mount
184.05 cm
(72.46 in.)
111.76 cm
(44.00 in.)
PD196