EFCO 403 Series Storefront - Manual (Page 51)

EFCO CORPORATION 1/2013 PART NO. Y001 Page 51 of 94
Series 401,402, & 403 Installation Instructions
Fig. # 30
Fig. # 29
Fig. # 28
K-123
K-123
BOTH SIDES OF A VERTICAL,
THE SIDE LITE BASE IS USED ON
NOTE: (4) HOLES ARE REQUIRED IF
# 8x2 1/2" F.H.
S-109
# 8x2 1/2" F.H.
S-109
(.147 Dia.)
#26 Drill
SEE NOTE & FIG. #30
# 26 (.147 Dia.) Drill
1/2" 2"
DOOR BOTTOM RAIL.)
(ALIGN WITH TOP OF
9132
1"
2"
9131
SHEAR BLOCK
K-123
BASE TOP OF SIDE LITE
BOTTOM
1/2" 2"
(.147 Dia.)
#26 Drill
9138
SHEAR BLOCK
K-123
#12 x 3/4" FH - F
S123
DOOR BOTTOM RAIL.)
(ALIGN WITH TOP OF
9132
1"
2 1/2"
9137
BASE TOP OF SIDE LITE
BOTTOM
- 401 SYSTEM 0NLY -
SECTION III: F. HIGH SIDE LITE BASES
Vertical member prep for narrow side lite base shear block.
Shear block attachment is required.
Side lite bases are available to match bottom door rails. STEP 2)
4 11/1
6
" to
5
9/16" SIGH
T LI
NE
6"
to 7 7/8" SI
G
H
T
L
INE
S401 SYSTEM - 1/4" GLAZING ONLY -
OPPOSITE SHEAR BLOCK
IS REVERSED.
9102
SHEAR BLOCKS LOCATE
IN GASKET TRACKS.
DRILL THRU (2) WALLS
BELOW