EFCO 403 Series Storefront - Manual (Page 85)

EFCO CORPORATION 1/2013 PART NO. Y001 Page 85 of 94
Series 401,402, & 403 Installation Instructions
VERTICAL
TYP. VERTICAL
GLASS UNIT BELOW
HWD1 WATER DEFLECTOR
screws and across the
Seal over the attachment
the vertical glazing pocket
and over the lower glass
This end extends into
Fig. # 100
unit's corner.
horizontal joint.
Fig. # 101
TYP. HORIZONTAL
WATER DEFLECTOR INSTALLATION
HWD1 WATER DEFLECTOR
(TYPICAL FOR S-402 AND S403)
TYP.
SECTION V: A.
9236
9336
Seal the inside glazed horizontal to
the vertical at the inside face of the
glazing pocket.
Apply a thin coat of silicone sealant to the end of
the horizontal. Set the HWD1 into the sealant and
allow to cure prior to installing glass.
Horizontal is cut out to
show deflector and
joint seal.