EFCO 403 Series Storefront - Manual (Page 64)

EFCO CORPORATION 1/2013 PART NO. Y001 Page 64 of 94
Series 401,402, & 403 Installation Instructions
This may cause the caulk joint at the jamb to increase in thickness,
The end cap edges must also be concealed with the sealant
The end caps must be sealed to the condition
Incorporating the sill flashing end caps will complement
and the sealant must tie in with the jamb blocking
if the condition is irregular.
to present a neat and clean installation.
the sealing procedure.
and the perimeter seals.
Fig. # 64
K448 or
K449
to ensure a watertight seal.
VIEW AT JAMB AND CONDITION
and the jamb member set in a bead of sealant
The sill flashing must be sealed to the condition
SILL FLASHING INSTALLATION
SECTION IV: B.
TYPICAL SILL MEMBER