Rice Lake CW-90X Over/Under/Washdown Checkweigher - Lantronix MatchPort - Manual (Page 24)

Configuration Using Web-Manager
MatchPort b/g™ User Guide
24
prevents the unit from entering monitor mode by interpreting
the stream of characters that are received during the device
server's initialization at startup.
CPU Performance Mode Select the MatchPort’s performance mode. Higher
performance settings require more energy. Low is 26 Mhz;
Regular is 48 Mhz; High is 88 Mhz. The default is Regular.
HTTP Server Port This option allows the configuration of the web server port
number. The valid range is 1-65535. The default HTTP server
port number is 80.
Config Server Port Allows for the configuration of the 0x77FE server port number.
Enter a number between 1 and 65535. The 0x77FE port is
used in bridging mode to discover Lantronix device servers
behind a bridge. The default 0x77FE server port number is
30718.
MTU Size The Maximum Transmission Unit (MTU) is the largest physical
packet size a network can transmit for TCP and UDP. Enter
between 512 and 1400 bytes. The default is 1400 bytes.
Host List Configuration
The MatchPort scrolls through the host list until it connects to a device listed in the
host list table. After a successful connection, the unit stops trying to connect to any
others. If this connection fails, the unit continues to scroll through the table until the
next successful connection.
The host list supports a minimum of 1 and a maximum of 12 entries. Each entry
contains an IP address and a port number.
Note: The host list is disabled for Manual and Modem Mode. The unit does
not accept a data connection from a remote device when the hostlist option is
enabled.
To configure the MatchPort’s host list:
1. On the main menu, click the Hostlist tab to open the Hostlist Settings page.