Rice Lake CW-90X Over/Under/Washdown Checkweigher - Lantronix MatchPort - Manual (Page 72)

Configurable Pins
MatchPort b/g™ User Guide
72
Command Parameter 1 Parameter 2
Byte 0 1 2 3 4 5 6 7 8
Pin Number 0 7 8 15 16 23 24 31 0 7 8 15 16 23 24 31
On some commands, one or all parameters are ignored.
For UDP, command type and parameters need to be in the same datagram.
Responses to valid commands are always five bytes long, consisting of the returned
command byte and as parameters in the current or updated values. In case of an
invalid command, only one byte with value 0FFh is returned.
Command Parameter 1
Byte 0 1 2 3 4
Pin Number 0 7 8 15 16 23 24 31
When sending a command (TCP and UDP), wait for the response before sending the
next command.
Commands
Byte 0 Command Types
10h Get functions
11h Get directions (input or output)
12h Get active levels (high active or low active)
13h Get current states (active or not active)
19h Set directions
1Ah Set active levels
1Bh Set current states
There is no Set functions command. Since the pin’s function depends on the
hardware in which the MatchPort is embedded, that configuration is only allowed via
77FE. Settings changed by any of the Set commands are not stored and are lost
when the unit is powered down or rebooted.
Command 10h, Get Functions
Send:
No parameters
Response:
1 parameter
Bytes 1-4: Functions
Bit X 1 means general purpose IO available to the user.
0 means dedicated function (e.g., serial flow control, diagnostics) for
configurable pin X.