Configuration via serial mode or telnet port, Accessing setup mode, Telnet access – Rice Lake CW-90X Over/Under/Washdown Checkweigher - Lantronix MatchPort User Manual
Page 40: Figure 5-1. mac address, Configuration via serial mode or, Telnet port, Configuration via, Serial mode or telnet port, Configuration via serial mode or telnet, Port
MatchPort b/g™ User Guide
40
5
5
:
:
C
C
o
o
n
n
f
f
i
i
g
g
u
u
r
r
a
a
t
t
i
i
o
o
n
n
v
v
i
i
a
a
S
S
e
e
r
r
i
i
a
a
l
l
M
M
o
o
d
d
e
e
o
o
r
r
T
T
e
e
l
l
n
n
e
e
t
t
P
P
o
o
r
r
t
t
As an alternative to Web-Manager, you can configure the MatchPort unit using a
terminal program to access serial port 1 locally. Using this terminal program to
respond to prompts is referred to as being in Setup Mode.
Another way to access
Setup Mode is over the network through a Telnet connection.
The unit’s configuration is stored in nonvolatile memory and is retained without
power. You can change the configuration at any time. The unit performs a reset after
the configuration has been changed and stored.
Note:
The menus in this section show a typical device. Not all devices
display information in the same manner.
Accessing Setup Mode
Telnet Access
To configure the unit over the network, establish a Telnet connection to port 9999.
Note:
Alternatively, use DeviceInstaller to access Telnet. Select the device from the
main page list, and click the Telnet Configuration tab in the right page. If using
Telnet from the DeviceInstaller toolbar, skip steps 1 through 3.
1. From the Windows Start menu, click Run.
2. From the Run dialogue box, type the following command (where x.x.x.x is the IP
address and 9999 is the unit’s fixed network configuration port number):
Windows: telnet x.x.x.x 9999
UNIX: telnet x.x.x.x:9999
3. Click OK. The following information displays:
Figure 5-1. MAC Address
MAC address 00204A89E06A
Software version V6.7.0.0RC6 (100118)
AES library version 1.8.2.1
Press Enter for Setup Mode
4. To enter the Setup Mode, press Enter within 5 seconds.
Note:
The connection fails if you do not press Enter within 5 seconds.
5. The configuration settings display, followed by the setup menu options: