Figure 4-9. udp connection settings – Rice Lake CW-90X Over/Under/Washdown Checkweigher - Lantronix MatchPort User Manual
Page 31
Configuration Using Web-Manager
MatchPort b/g™ User Guide
31
Figure 4-9. UDP Connection Settings
Datagram Mode
Datagram Type
Configures the remote IP or network broadcast address and
the remote port. Enter 01 for directed or broadcast UDP.
Accept Incoming
Select Yes to accept incoming UDP datagrams. Other options
are No and With Active Mdm Ctrl In.
Endpoint Configuration
Local Port
Enter the local port number.
Remote Port
Enter the port number of the remote device.
Remote Host
Enter the IP address of the remote device.
Use Broadcast
Select to broadcast the UDP datagram. Datagrams of type 01
can be sent as a broadcast by enabling this option. The
default is not to broadcast.
Note:
Datagrams are sent as subnet-directed broadcasts.
Device Address Table
This table is enabled when Datagram Type is set to FD. Enter
values in the range 1-255 to identify units on the local network
of device servers.
Note:
Lantronix Tech Support supports Datagram type 01.
Datagram type FD is for OEM use.