Rice Lake CW-90X Over/Under/Washdown Checkweigher - Lantronix MatchPort - Manual (Page 68)

Configuration via Serial Mode or Telnet Port
MatchPort b/g™ User Guide
68
Disable Port 77F0h ? _
The default setting, the N (No) option, enables GPIO control. The Y (Yes) option
disables the GPIO control interface.
Default Settings
Select 7 Defaults from the Change Setup menu to reset the unit’s Channel 1
configuration, Channel 2 configuration, Email settings, and Expert settings to the
factory default settings. The server configuration settings for IP address, gateway IP
address, netmask, wireless enable, infrastructure or ad hoc setting, and wireless
security settings remain unchanged. The configurable pins’ settings also remain
unchanged. The specific settings this option changes are listed below.
Note: To reset network settings to factory defaults, use one of the “Reset to
Defaults” Configurable Pin Settings. For more information on Configurable
Pins, see
Configurable Pins page 71 .
Channel 1 and Channel 2 Configuration
Baudrate 9600
I/F Mode 4C (1 stop bit, no parity, 8 bit, RS-232C, no flow
control)
Port No 10001 on Channel 1
10002 on Channel 2
Connect Mode C0 (always accept incoming connection; no active
connection startup)
Hostlist Retry Counter 3
Hostlist Retry Timeout 250 (msec)
Send Character 0x0D (CR)
All other parameters 0
WLAN Settings
Topology 1 (AdHoc)
Network Name LTRX_IBSS
Channel 11
Security 0 (none)
TX Data Rate Auto Fallback
1
1 (auto)
TX Data Rate
1
54 Mbps
1
This is included in the 7 Defaults menu reset. To reset the other WLAN settings, use one of the
“Reset to Defaults” Configurable Pin settings. For more information on Configurable Pins, see
Configurable Pins on page 70.