Rice Lake CW-90X Over/Under/Washdown Checkweigher - Lantronix MatchPort - Manual (Page 44)

Configuration via Serial Mode or Telnet Port
MatchPort b/g™ User Guide
44
 Custom DHCP Name: Create your own DHCP name. If using an IP address
of 0.0.0.0, the last option in Server configuration is Change DHCP device
name. This option allows you to change the DHCP name to an alphanumeric
name (LTX in the example).
Change DHCP device name (not set) ? (N) Y
Enter new DHCP device name : LTX
 Numeric DHCP Name: You can change the DHCP name by specifying the
last octet of the IP address. When you use this method, the DHCP name is
LTXYY where YY is what you chose for the last octet of the IP address. If the
IP address you specify is 0.0.0.12, the DHCP name is LTX12. This method
only works with 2-digit numbers (0-99).
The third octet of the IP address sets the BootP/DHCP/AutoIP options. To
disable an option, set the appropriate bit:
Table 5-2. BootP/DHCP/AutoIP Options
Options Bit
AutoIP 0
DHCP 1
BootP 2
For example, if the third octet is 0.0.5.0, the AutoIP and BootP options are
disabled; only DHCP is enabled. (The value 5 results from adding the binary
equivalents of 0 and 2.) This is the most common setting when using DHCP.
Channel 1 and Channel 2 Configuration
Select option 1 Channel 1 or 2 Channel 2 from the Change Setup menu to define
how the serial port responds to network and serial communications
. The following
sections describe the configurable parameters within the Channel configuration
menu.
Figure 5-5. Serial and Telnet Port Parameters
Baudrate
The unit and attached serial device, such as a modem, must agree on a speed or
baud rate to use for the serial connection. Valid baud rates are 300, 600, 1200, 2400,
4800, 9600 (default), 19200, 38400, 57600, 115200, 230400, 460800, and 921000.