Trigger configuration, Figure 4-11. email trigger settings – Rice Lake CW-90X Over/Under/Washdown Checkweigher - Lantronix MatchPort User Manual
Page 33
Configuration Using Web-Manager
MatchPort b/g™ User Guide
33
Trigger Configuration
A trigger event occurs when the unit receives either one or two bytes of a specified
sequence on the serial port, or because of a specified combination of conditions on
the configurable pins.
Set the configurable pins to Active, Inactive, or None. The configurable pins are
disabled if they are all set to none. If both the serial sequence and the configurable
pins are disabled, the trigger is disabled.
To configure the MatchPort’s email trigger settings:
1. On the main menu, click Trigger 1, Trigger 2, or Trigger 3 to configure the
desired Trigger settings. The Email Trigger Settings page opens.
Figure 4-11. Email Trigger Settings
2. Configure the following fields:
Conditions
Configurable Pins
Select the condition from the drop-down list for the
configurable pins. Repeat for each Trigger Input field.
Serial Trigger
Enable Serial Trigger
Input
When selected, specified serial communications count as a
trigger input.
Channel
Select the channel prompting the trigger.
Data Size
Select the data size prompting the trigger.
Match Data
Enter the data that, when it appears in the communication
stream, prompts a trigger.
Note:
All of the conditions must match to send an email notification.