Rice Lake MC Series Mass Comparator, A&D Weighing - MC-6100 - Manual (Page 16)

14
5. WEIGHING
5-1 Selecting the Weighing Units (Modes)
The unit “g” (gram) was set at the factory.
To use other units, select and store units and displaying order in the function setting of “ Unit ”.
For details on weighing unit selection procedure, refer to the GX series instruction manual, “5.
WEIGHING UNITS”.
5-2 Basic Weighing
When using as a mass comparator
z To reduce the influence of drafts and vibration, set the following function settings as below.
“Condition ( Cond )” of “Environment, Display ( ba5fnc )” to “Slow ( 2 )”
“Filter ( f1l )” of ““Environment, Display ( ba5fnc )” to “Used (1 )”
For details, refer to “9. FUNCTION TABLE”.
z To avoid eccentric loading errors, place the sample in the center of the weighing pan.
As an option, auto-centering pans are available: AX-MC1000PAN for the MC-1000 and
AX-MC6100PAN for the MC-6100.
Using an AD-8922A remote controller, which is sold separately, the balance can be controlled
remotely by the AD-8922A key operations in the same way as when the CAL or
RE-ZERO key of the balance is pressed. For the connection procedure between the balance
and the AD-8922A, refer to the AD-8922A instruction manual.
z Take measures against causes of weighing error at the installation site, such as changes in
temperature, atmospheric pressure, drafts, vibration and static electricity. Perform weighing
operations in a stable environment.
z The table below lists the weight class and recommended measuring range for each model of
the MC series. The measuring range is determined so that the balance repeatability is to be
less than one third of the maximum permissible error for each weight class.
Weight class and recommended measuring range
Weight
(Displayed value)
Model
Class
5 kg
2 kg
1 kg
500 g
200 g
100 g
50 g
20 g
10 g
5 g
2 g
1 g
500 mg
200 mg
100 mg
F 1 F 2 M 1 M 2 F 1 F 2 M 1 M 2
M C - 1 0 0 0 M C - 6 1 0 0
F 1 F 2 M 1 M 2