Rice Lake MC Series Mass Comparator, A&D Weighing - MC-6100 - Manual (Page 27)

25
4 Press the PRINT key. Then the balance displays the
function switches.
Set the function table switch and internal mass correction
switch to “ 1 ” as shown above using the following keys.
SAMPLE key To select the switch to change the value.
RE-ZERO key To change the parameter of the switch
selected.
5 Press the PRINT key to store the new setting. The
balance returns to the weighing mode.
6 Press and hold the SAMPLE key to enter the function
table and release the key when ba5fnc is displayed.
7 Press the SAMPLE key several times until C5in is
displayed.
8 Press the PRINT key to enter the procedure for correcting
the internal mass value.
9 Correct the internal mass value using the following keys.
RE-ZERO key To select the value.
(-20 digits appear after +20 digits.)
PRINT key To store the new value and display the
next menu of the function table.
CAL key To cancel the correction and display
the next menu of the function table.
10 Press the CAL key. The balance returns to the weighing mode.
11 Press the CAL key to calibrate the balance using the
internal mass.
12 Place the external weight on the pan and confirm that the correction has been performed
properly (Confirm that the value displayed is within the range that is described at “Accuracy
right after calibration using the internal mass” of “17. SPECIFICATIONS”.)
If the internal mass value has not been corrected properly, repeat the procedure, starting at
step 6 and adjust the correction value.
Press and
hold