Rice Lake MC Series Mass Comparator, A&D Weighing - MC-6100 - Manual (Page 38)

36
KF format 5if type 2
This is the Karl-Fischer moisture meter format and is used when the peripheral equipment can only
communicate using this format.
z This format consists of fourteen characters excluding the terminator.
z This format has no header characters.
z The polarity sign is placed before the data, with spaces in place of leading zeros, if the data is
not zero or overloaded.
z This format outputs the unit only for a stable value.
MT format 5if type 3
z A header of two characters indicates the balance condition.
z The polarity sign is used only for negative data.
z The weighing data uses spaces in place of the leading zeros.
z The character length of this format changes dependent upon the unit
NU (Numerical) format 5if type 4
This format outputs only numerical data.
z This format consists of nine or ten characters excluding the terminator.
With the MC-1000, when the numerical data excluding the decimal point exceeds eight
characters, the data format will be ten characters long.
z The polarity sign is placed before the data with the leading zeros. If the data is zero, the plus
sign is used.
(Data example exceeding 8 characters)
+ 1 0 0 0 . 0 0 0 0 g CR LF
Data Unit Terminator
S 1 0 0 0 . 0 0 0 0 g CR LF
Header Unit Terminator Data
+ 0 0 0 . 0 1 2 7 CR LF
Data Terminator
+ 1 0 0 0 . 0 0 0 0 CR LF
Data Terminator
g Stable value
Unstable value