Rice Lake TradeRoute HL Series - Low Profile Operators Manual for Models from 2011 and Older 127465 - Manual (Page 10)

7
4. Operating Instructions
Weigh Mode Alarms
Your On-Board Weighing System is equipped with both a
hardware and software alarm to alert the operator when the scale
is in the weigh position. When the M2000 is ON the system
automatically monitors the weight on the scale. When the scale is
up the system software will automatically flash the alarm light
located in the cab of the truck, on truck mounted models. The
alarm light is located on the side of the control box on trailer
mounted units. When the scale is lowered into the transport
position the software automatically turns the alarm lamp off.
As a backup to the software alarm, the system also uses a
hardware alarm that will function even when the power switch is
in the OFF position. When the M2000 is off the system can no
longer monitor the weight on the scale. Instead a hardware alarm
monitors the position of the scale. If you cut the power to the
system with the scale is in the weigh position, the alarm light will
turn on solid. The alarm light will remain on until the scale is
lowered into the transport position.