Rice Lake TradeRoute HL Series - Low Profile Operators Manual for Models from 2011 and Older 127465 User Manual
Page 35
32
Symptom
Probable Cause
Action
The level light will
not illuminate
a) the bulb is burnt
out
a) replace bulb Norac part #
101149
The level light will
not illuminate AND
the weight indicator
shuts off 10 seconds
after powering up
a) truck is more than
6 degrees off level
(Depending on
your application
you may be limited
to less than 6
degrees)
b) faulty tilt sensor
a) return the truck to a level
position before unloading
b) contact your local dealer or
Rice Lake Weighing Systems
for a tilt sensor Norac part #
42328.55
The alarm light stays
on all the time.
a) The scale up/down
sensor may be
damage or not
working.
a) Check that the finger shaped
reed switch is oriented properly
and not broken. (See sketch
following this table) – OR – make
sure the magnet has not fallen off
or been moved out of position.
Norac scale up/down sensor part
#42377
The cab alarm light
stays OFF all the
time.
a) Broken wire or
bad connection in
the cab alarm
assembly.
a) Fix broken wire or bad
connection – OR- replace cab
alarm assembly Norac part #
42331
The system will not
START or END or
both
a) Weight reading is
not stable enough
a) It may be too windy to get a
stable weight, check the
motion light on the indicator.
The system can only start and
end when the light is out.