Rice Lake TradeRoute HL Series - Low Profile Operators Manual for Models from 2011 and Older 127465 - Manual (Page 34)

31
6. Trouble Shooting
Symptom Probable Cause Action
The scale indicator
will not power up. a) Blown in-line fuse
b) Truck voltage is
less than 11 volts.
a) Replace in-line fuse, Norac
part # 100494, the fuse
holder should be located near
the battery or inside the cab.
b) Repair faulty electrical system
on truck. The panel requires
at least 11 volts to operate
properly.
Indicator turns off
or resets in the
middle of a
transaction –OR-
End button will not
function but start
seems to work
properly.
a) Low voltage to
control panel.
a) Check other electrical
equipment that may be
operating (IE. Air
conditioning). The charging
system on the vehicle may not
be maintaining at least 11
volts.
The M2000 will not
come on
automatically with
the system power
switch- it will only
power up when the
ON button on the
M2000 panel is
pushed – AND- The
indicator turns on
and off erratically
even when the level
light is on solid.
a) The indicator must
be configured to
power up
automatically.
a) Contact your local dealer or
Rice Lake Weighing Systems.
Only a qualified technician can
perform this configuration.