Rice Lake TradeRoute HL Series - Low Profile Operators Manual for Models from 2011 and Older 127465 User Manual
Page 19
16
4. Insert your ticket into the TM290 ticket printer.
5. The system is in IDLE condition and the display is showing a
stable GROSS weight, which is the starting weight.
If you have a delivery switch make sure the delivery hose,
chutes, conveyors, etc. must be in the storage position
before continuing.
If you don’t have a delivery switch make sure the delivery
hose, chutes, conveyors, etc. must be in position to
delivery product before continuing.
6. If your system has a delivery switch ensure it is “off”. Press
[START]. The prompt “setp” will appear, enter the target
weight. Set the target weight (set point) by entering the
following sequence into the M2000.
“#####” is the target weight.
If a mistake is made entering the target weight, pressing
[CLEAR] will abort the enter target weight phase. Press
[START] to start the enter target weight process again.
If the target weight has not been entered and the system
is not prompting you to enter a target weight, you will
need to press [START] again. You will then be prompted
to enter a target weight.
7. If the system is in Batch Weigh mode the system will prompt
“prod”, enter a product ID enter
“#####” is the product number.
If the product number has not been entered and the
system is not prompting you to enter a product number,
you will need to press [START] again. You will then be
prompted to enter a product number.