Rice Lake TradeRoute HL Series - Low Profile Operators Manual for Models from 2011 and Older 127465 - Manual (Page 20)

17
If a mistake is made entering the product number,
pressing [CLEAR] will abort the enter product number
phase. Press [START] to start the enter product number
process again.
8. The M2000 will go into NET mode automatically when steps 6
and/or 7 are complete. The display will show zero with the
net light illuminated. If the system is not in NET weigh the
product number and/or the target weight has not been
entered. Refer to the notes in step 6 and 7.
Note: If you don’t have a delivery switch the delivery
pump will start at this step.
9. Position the delivery hoses (chutes, conveyors, etc) to deliver
product.
10. If your system has a delivery switch turn it “on”. The delivery
pump will start. The weight indication will begin changing as
product is unloaded or loaded.
11. Wait for pump to stop. The pump will stop pumping when the
weight reading on the M2000 reaches the target weight.
12. If your system has a delivery switch turn it “off”.
13. Disconnect the delivery hoses and place back in the storage
position.
Note: The delivery hoses must be in the storage position
before pushing the END button.
14. If your system is in Single Weigh mode press [END]. Wait for
ticket to finish printing. If your system is in Batch Weigh mode
there are now two choices.
-
If this is the end of all weighing, push [END]. The system
will then print out the last batch ingredient and the
accumulated total weight in the “Total Product” line on
the ticket. The system will then return to the IDLE
condition.