Rice Lake TradeRoute HL Series - Low Profile Operators Manual for Models from 2011 and Older 127465 - Manual (Page 15)

12
Note: If the product number has not been entered
and the system is not prompting you to enter a
product number, you will need to press [START]
again. You will then be prompted to enter a product
number.
7. The system will then go into NET weigh mode showing zero
“  ”. If the system is not in NET weigh the product number has
not been entered. Refer to the notes above.
8. Add or remove product until the desired weight is reached.
Stop loading or unloading and return the delivery system to
the storage position and wait for the reading to stabilize.
There are now two choices.
-
If this is the end of all weighing, push [END]. The system
will then print out the last batch ingredient and the
accumulated total weight in the “Total Product” line on
the ticket. The system will then return to the IDLE
condition.
-
To start another weighment press the [START] button
again and repeat steps 5-9.
9. The process will loop in STEPS 5-9 and only exit by pushing
[END].
The delivery hoses chutes, conveyors, etc. must be in
the storage position before pressing [END].
Date: Jun 16, 2008 Time: 13:15
Product # xxxxxx 1234 KGS
Product # yyyyyy 1122 KGS
Product # zzzzzz 2134 KGS
Total Product: 4490 KGS
The above ticket will print in either Kilograms (kg) or Pounds (lb)
depending on your system settings.