Rice Lake TradeRoute HL Series - Low Profile Operators Manual for Models from 2011 and Older 127465 - Manual (Page 18)

15
Note: It is strongly recommended that a delivery switch
is installed. If there is no delivery switch, the pump could
start before the user is ready to deliver. This can cause
improper dispensing of product.
Configuring Set Point Operation
1. There are 3 operating modes for the Set Point Relay. To
change the Set Point Relay Operation enter
2. The display will prompt “setsr”, at this point enter the
desired operation by pressing
With ‘#’ being the Set Point operating mode. See table below
for operating modes.
Mode Operation
0 Set Point Relay is off and never activates
1 Set Point Relay is in Manual Operation.
2 Set Point Relay is in Automatic Operation
Automatic Set Point Relay Operation
1. Park the vehicle in as level a location as possible.
2. Raise the platform to enable the scale. If the level lamp does
not indicate that the unit is level, lower the platform and move
the truck. Repeat steps 1 and 2.
3. Turn the power switch located on the instrument panel to the
ON position. The M2000 weigh indicator should power up.
The readout on the indicator should be positive.
Note: The M2000 will display off level after 10 seconds if
the vehicle is not level.