Rice Lake TradeRoute HL Series - Low Profile Operators Manual for Models from 2011 and Older 127465 - Manual (Page 32)

29
16. Clean any Loctite that remains in the bushing locations.
Assembly Procedure
See parts list drawing on page 20 and drawing on Page 28.
1. Install the new bushings into the lift arms using Loctite 603
only. Any other products used to retain the bushings must
resist mild oil contamination.
2. Insert lower load cell pin (34) into lift plate (36 or 43) insert
roll pin (17) to hold the pin in place with roll pin punch and
hammer.
3. Assemble inner lift arm (4 or 6) onto pivot pin on base (35 or
42).
4. Assemble hydraulic cylinder onto lower cylinder pin on base
(35 or 42).
5. Insert upper cylinder pin (8) through cylinder (1) into the
inner lift arm (4 or 6).
6. Assemble load cell assembly (32,33) onto lower load cell pin
(34).
7. Apply a thin film of grease onto ends of upper load cell pin
(31).
8. Insert upper load cell pin (31) through upper eyebolt (33) into
inner lift arm (4 or 6).
9. Assemble outer lift arm (5 or 7) loosely onto the three pins
(pivot, upper load cell, and upper cylinder).
10. Place lift arm spacer (9) between two lift arm plates and press
outer lift arm fully onto the pins.
11. Insert cap screw (10,11) and start threads, do not tighten, with
3/4” Allen key.
12. Insert pivot bolt (13), washer (15) and lock washer (14) into
pivot pin and tighten with 3/4” wrench.
13. Tighten cap screw (10,11) with 3/4” Allen key.
14. Turn out the lock down bolt (18) until cylinder is extended
between 1/8” and 1/4” with 3/4” wrench. Tighten the jam nut
(19).