Rice Lake TradeRoute HL Series - Low Profile Operators Manual for Models from 2011 and Older 127465 - Manual (Page 14)

11
Batch Weigh Operating Instructions
1. Park the vehicle in as level a location as possible.
2. Raise the platform to enable the scale. If the level lamp does
not indicate that the unit is level, lower the platform and move
the truck. Repeat steps 1 and 2.
3. Turn the power switch located on the instrument panel to the
ON position. The M2000 weigh indicator should power up.
The readout on the indicator should be positive. When the
system is ready to use the green LED on the front panel will
go dark.
Note: The M2000 will display  after 10
seconds if the vehicle is not level.
4. Insert your ticket into the TM290 ticket printer.
The delivery hose, chutes, conveyors, etc. must be in
the storage position before continuing.
5. To start the cycle, press [START]. This will print the time
and date.
6. The prompt “prod” will appear, enter the product ID.
“#####” is the product number from 1-999999.
Note: If a mistake is made entering the product
number, pressing [CLEAR] will abort the enter
product number phase. Press [START] to start the
enter product number process again.