Rice Lake TradeRoute HL Series - Low Profile Operators Manual for Models from 2011 and Older 127465 - Manual (Page 38)

35
Symptom Probable Cause Action
The printer is
printing
unrecognisable
characters
a) The printer DIP
switch setting are
incorrect
b) The power supply
on the truck is
excessively noisy.
a) Turn the printer over and
check that the small switches
are set as follows: 1 on, 2 off,
3 off, 4 off, 5 off, 6 off, 7 on,
8 on, 9 off, 10 off
b) Contact Rice Lake Weighing
Systems, an in-line power
filter may be necessary.
The printing on the
ticket is faint or
hard to read. a) The printer’s ink
ribbon may need to
be replaced.
b) The printer head
may be damaged.
a) replace ribbon, Norac part #
82282-1
b) Requires service by a
qualified technician.
Cannot load the
system to full
capacity without
getting “
 ” on
the display
a) Dead load has been
added to the scale
since it was
calibrated
a) Contact your local scale dealer
Display reads
“
 ” or “  ”
a) A load cell has
become
disconnected.
a) Inspect for damage and
consult you local scale
dealer.
IF YOU SUSPECT THERE IS A PROBLEM INSIDE THE
CONTROL PANEL THAT REQUIRES THE WEIGHTS AND
MEASURES SEAL TO BE BROKEN YOU MUST CONTACT
RICE LAKE WEIGHING SYSTEMS PRIOR TO BREAKING THE
SEAL, OR HAVE A QUALIFIED SCALE DEALER BREAK THE
SEAL.
BREAKING THE SEAL MAY VIOLATE THE WEIGHTS AND
MEASURES APPROVAL OF THE SCALE.